R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
[SENSe:]MIXer:LOSS:TABLe:HIGH
SENSe Subsystem
This command sets the conversion loss table for higher harmonics in bands with two harmonics.
Parameter: := file name
Example: "MIX ON"
"MIX:LOSS:TABL:HIGH mix_1_6"
Characteristics: *RST value: no table set
SCPI: device-specific
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
[SENSe:]MIXer:LOSS:TABLe[:LOW]
This command selects a conversion loss table and sets it for the active band. If two harmonics are used
for the band, it is set for the lower harmonic.
Parameter: := file name
Example: "MIX ON"
"MIX:LOSS:table mix_1"
Characteristics: *RST value: no table set
SCPI: device-specific
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
[SENSe:]MIXer:PORTs 2 | 3
This command activates the 2- or 3-port mixer. The command refers to the active band selected with
SENSe:MIXer:HARMonic:BAND.
Example: "MIX ON"
"MIX:PORT 3"
Characteristics: *RST value: 2
SCPI: device-specific
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
[SENSe:]MIXer:SIGNal ON | OFF | AUTO | ALL
In analyzer mode, this command activates the Signal ID (ON) or Auto ID (AUTO) mode or both (ALL).
Example: "MIX ON"
"MIX:SIGN ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
6.188 Operating Manual 1313.9681.12 - 01