R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
6.5.6.2 CALCulate:MARKer:FUNCtion Subsystem
The measurement window is selected by CALCulate 1 (screen A) or 2 (screen B).
CALCulate Subsystem
CALCulate:MARKer:FUNCtion:CENTer
This command sets the center frequency of the selected measurement window equal to the frequency
of the indicated marker.
If marker 2, 3 or 4 is selected and used as delta marker, it is switched to the marker mode.
Example: "CALC:MARK2:FUNC:CENT"
'Sets the center frequency of screen A to the frequency of marker 2.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A-F
This command is an "event" and therefore has no *RST value and no query.
CALCulate:MARKer:FUNCtion:CSTep
This command sets the step width of the center frequency in the selected measurement window to the
X value of the current marker.
If marker 2, 3 or 4 is selected and used as delta marker, it is switched to the marker mode.
Example: "CALC2:MARK3:FUNC:CST"
'Sets the center frequency of screen B to the same value as the frequency of
marker 3.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A-F
This command is an event and therefore has no *RST value and no query.
CALCulate:MARKer:FUNCtion:DEModulation:CONTinuous ON | OFF
This command switches on or off the continuous demodulation in the frequency domain (span >0) in
the selected measurement window. Thus acoustic monitoring of the signals can be performed in the
frequency domain. The function does not depend on the selected marker, i.e. the numeric suffix
is irrelevant.
Example: "CALC2:MARK3:FUNC:DEM:CONT ON"
'Switches on the continuous demodulation in screen B.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
6.54 Operating Manual 1313.9681.12 - 01