R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
6.17 SOURce Subsystem
SOURce Subsystem
The SOURce subsystem controls the output signals of the R&S FSQ if the option External Generator
Control (R&S FSP-B10) is installed. The measurement window is selected by SOURce1 (screen A) and
SOURce2 (screen B).
6.17.1 Internal Tracking Generator
SOURce:DM:STATe ON | OFF
This command switches on or off the external I/Q modulation of the tracking generator in the selected
measurement window.
External AM and external FM are switched off, if active. This command is only valid in conjunction with
the tracking generator option B9.
Example: "SOUR2:DM:STAT ON"
'Switches on the external I/Q modulation of the tracking generator for screen B.
Characteristics: *RST value: OFF
SCPI: conform
Mode: A
SOURce:FM:DEViation 100Hz to 10MHz
This command defines the maximum frequency deviation at 1 V input voltage at the FM input of the
tracking generator.
The possible value range is 100 Hz to 10 MHz in steps of one decade.
This command is only available in connection with the Tracking Generator Option B9.
Example: "SOUR:FM:DEV 1MHz"
'Sets the maximum frequency deviation of the tracking generator for screen A to 1
MHz.
Characteristics: *RST value: 100 Hz
SCPI: conform
Mode: A
SOURce:FM:STATe ON | OFF
This command switches on or off the external frequency modulation of the tracking generator in the
selected measurement window.
External I/Q modulation is switched off, if active. This command is only valid in conjunction with the
tracking generator option B9.
Example: "SOUR:FM:STAT ON"
'Switches on the external frequency modulation of the tracking generator for
screen A.
Characteristics: *RST value: OFF
SCPI: conform
Mode: A
6.212 Operating Manual 1313.9681.12 - 01