R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
CALCulate Subsystem
Example: "CALC:MARK2:MIN:RIGH"
'Positions marker 2 in screen A to the next higher minimum value to the right of the
current value.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
CALCulate:MARKer:PEXCursion
This command defines the peak excursion, i.e. the spacing below a trace maximum which must be
attained before a new maximum is recognized, or the spacing above a trace minimum which must be
attained before a new minimum is recognized. The set value is valid for all markers and delta markers.
The unit depends on the selected operating mode.
Example: "CALC:MARK:PEXC 10dB"
'Defines peak excursion 10 dB.
Characteristics: *RST value: 6dB
SCPI: device-specific
Mode: A
The numeric suffix in MARKer is irrelevant.
CALCulate:MARKer[:STATe] ON | OFF
This command switches on or off the selected marker. If no indication is made, marker 1 is selected
automatically. If marker 2, 3 or 4 is selected and used as a delta marker, it is switched to marker mode.
The measurement windows are selected via CALCulate1 (screen A) or 2 (screen B).
Example: "CALC:MARK3 ON"
'Switches marker 3 in screen A on or to marker mode.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
CALCulate:MARKer:TRACe 1 to 3
This command assigns the selected marker (1...4) to the indicated measurement curve. The
corresponding trace must be active, i.e. its status must be different from "BLANK".
If necessary, the corresponding marker is switched on prior to the assignment.
The measurement windows are selected via CALCulate1 (screen A) or 2 (screen B).
Example: "CALC:MARK3:TRAC 2"
'Assigns marker 3 in screen A to trace 2.
"CALC2:MARK:TRAC 3"
'Assigns marker 1 in screen B to trace 3.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
6.50 Operating Manual 1313.9681.12 - 01