R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
SYSTem:COMMunicate:SERial[:RECeive]:BITS 7 | 8
SYSTem Subsystem
This command defines the number of data bits per data word for the serial interface (COM).
Example: "SYST:COMM:SER:BITS 7"
Characteristics: *RST value: -- (no influence on this parameter, factory default 8)
SCPI: conform
Mode: A
SYSTem:COMMunicate:SERial[:RECeive]:PACE XON | NONE
This command switches on or off the software handshake for the serial interface.
Example: "SYST:COMM:SER:PACE XON"
Characteristics: *RST value: -- (no influence on this parameter, factory default NONE)
SCPI: conform
Mode: A
SYSTem:COMMunicate:SERial[:RECeive]:PARity[:TYPE] EVEN | ODD | NONE
This command defines the parity check for the serial interface (COM).
Parameter: EVEN: even parity
ODD: odd parity
NONE: no parity check.
Example: "SYST:COMM:SER:PAR EVEN"
Characteristics: *RST value: -- (no influence on this parameter, factory default NONE)
SCPI: conform
Mode: A
SYSTem:COMMunicate:SERial[:RECeive]:SBITs 1|2
This command defines the number of stop bits per data word for the serial interface (COM).
Example: "SYST:COMM:SER:SBITs 2"
Characteristics: *RST value: -- (no influence on this parameter, factory default 1)
SCPI: conform
Mode: A
SYSTem:DATE 1980 to 2099, 1 to 12, 1 to 31
This command is used to enter the date for the internal calendar.
The sequence of entry is year, month, day.
Example: "SYST:DATE 2000,6,1"
Characteristics: *RST value: –
SCPI: conform
Mode: A
6.230 Operating Manual 1313.9681.12 - 01