R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
TRD FACTOR
NAME
TRD FACTOR
UNIT
TRD FACTOR
VALUES
Basic Settings
During editing, a transducer factor remains stored in the background until the factor
edited is saved with the SAVE TRD FACTOR softkey or until the table is closed. A
factor that was edited by mistake can be restored by leaving the entry function.
Name - Entry of name
The TRD FACTOR NAME softkey is used to enter the name of the transducer factor.
A maximum of 8 characters is permissible for the name. The characters have to
comply with the convention of DOS file names. If the name exceeds 8 characters,
the name is truncated. The unit automatically stores all transducer factors with the
extension .TDF. If an existing name is changed, the factor stored under the previous
name is retained and will not be overwritten automatically with the new name. The
previous factor can be deleted at a later time, using DELETE. Thus, factors can be
copied.
Remote command: CORR:TRAN:SEL
Unit – Selection of unit
The TRD FACTOR UNIT softkey gives access to a box for selecting the unit of the
transducer factor.
The default setting is dB.
Remote command: CORR:TRAN:UNIT
Entry of value
The TRD FACTOR VALUES softkey sets the scrollbar on the first reference value.
The desired reference values for FREQUENCY and TDF/dB must be entered in
ascending order of frequencies. After the frequency has been entered, the scrollbar
automatically goes to the associated level value.
The table can be edited after entry of the first value using the INSERT LINE and
DELETE LINE softkeys. To change individual values later on, the value has to be
selected and a new one entered.
Remote command: CORR:TRAN:DATA ,
Interpolation - Selection of interpolation
Linear or logarithmic interpolation can be performed between the frequency reference
values of the table. The ENTER key allows the user to select LIN or LOG (toggle
function).
Remote command: CORR:TRAN:SCAL LIN|LOG
Operating Manual 1313.9681.12 - 01 4.181