R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
4.1 Introduction
Introduction
All functions of the R&S FSQ and their application are explained in detail in this
chapter. The sequence of the described menu groups depends on the procedure
selected for the configuration and start of a measurement:
1. Resetting the instrument
– “R&S FSQ Initial Configuration – PRESET Key” on page 4.5
2. Setting the mode
– “Mode Selection – Hotkey Bar” on page 4.7
– “Return to Manual Operation – LOCAL Menu” on page 4.8
3. Setting the measurement parameters in analyzer mode
– “Analyzer Mode” on page 4.9
4. Basic functions for general settings, printout and data management
– “Setup of Limit Lines and Display Lines – LINES Key” on page 4.153
– “Configuration of Screen Display – DISP Key” on page 4.164
– “Instrument Setup and Interface Configuration – SETUP Key” on page 4.170
– “Saving and Recalling Data Sets – FILE Key” on page 4.205
– “Measurement Documentation – HCOPY Key” on page 4.214
5. Additional and optional functions
– “Tracking Generator – Option R&S FSU-B9” on page 4.221
– “External Generator Control – Option R&S FSP-B10” on page 4.235
– “LAN Interface - Option R&S FSP-B16” on page 4.252
– “LO/IF ports for external mixers - Option R&S FSU-B21” on page 4.279
– “Trigger Port – Option R&S FSP-B28” on page 4.415
The operating concept is described in the Quick Start Guide, chapter 4, “Basic Operation”.
The remote commands (if any) are indicated for each softkey. A detailed description
of the associated remote commands is given in chapter “Remote Control – Description
of Commands”.
4.4 Operating Manual 1313.9681.12 - 01