R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
CALCulate:DELTamarker:MINimum:RIGHt
CALCulate Subsystem
This command positions the specified delta marker to the next higher minimum value to the right of the
current value (i.e. ascending X values). The corresponding delta marker will be activated first, if
necessary.
Example: "CALC2:DELT:MIN:RIGH"
'Sets delta marker 1 in screen B to the next higher minimum value to the right of
the current value.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
CALCulate:DELTamarker:MODE ABSolute | RELative
This command switches between relative and absolute frequency input of the delta marker (or time
with span = 0). It affects all delta markers independent of the measurement window.
Example: "CALC:DELT:MODE ABS"
'Switches the frequency/time indication for all delta markers to absolute values.
"CALC:DELT:MODE REL"
'Switches the frequency/time indication for all delta markers to relative to marker 1.
Characteristics: *RST value: REL
SCPI: device-specific
Mode: A
Mode:
CALCulate:DELTamarker[:STATe] ON | OFF
This command switches on and off the delta marker if delta marker 1 is selected. If marker 2, 3 or 4 is
selected and used as a marker, it is switched to delta marker mode. If the corresponding marker is not
activated, it will be activated and positioned on the maximum of the measurement curve.
If no numeric suffix is indicated, delta marker 1 is selected automatically.
The measurement windows are selected via CALCulate1 (screen A) or 2 (screen B).
Example: "CALC:DELT3 ON"
'Switches marker 3 in screen A to delta marker mode.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
CALCulate:DELTamarker:TRACe 1 to 3
This command assigns the selected delta marker to the indicated measurement curve. The selected
measurement curve must be active, i.e. its state must be different from "BLANK".
The measurement windows are selected via CALCulate1 (screen A) or 2 (screen B).
Example: "CALC:DELT3:TRAC 2"
'Assigns deltamarker 3 to trace 2 in screen A.
Operating Manual 1313.9681.12 - 01 6.19