R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
WIBro WiMAX WiBro (Wireless Broadband) IEEE 802.16-2004/Cor1-2005
Example: "CALC:MARK:FUNC:POW:PRES BWLan"
Selects the standard setting for WLAN 802.11b.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A-F
CALCulate:MARKer:FUNCtion:POWer:RESult:PHZ ON | OFF
CALCulate Subsystem
EUTRa E-UTRA/LTE Square
Use this standard setting to measure the assumed adjacent channel carrier configuration, E-UTRA of
same BW. In this mode, on all channels a square filter is applied.
REUTra E-UTRA/LTE Square/RRC
Use this standard setting to measure the assumed adjacent channel carrier configuration, 1.28, 3.84, 7.68,
Mcps UTRA. In this mode, a square filter is applied to the Tx channel and a RRC filter is applied to the
adjacent, alternate channels.
is the file name of a customized standard that has been saved with SAVE AS USER STD.
The settings for standards IS95A and C differ as far as the calculation method of
channel spacings is concerned. For IS95A and J-STD008 the spacing is calculated
from the center of the main channel to the center of the corresponding adjacent
channel, for IS95C from the center of the main channel to the nearest border
of the adjacent channel.
This command switches the query response of the power measurement results in the indicated
measurement window between output of absolute values (OFF) and output referred to the
measurement bandwidth (ON).
The measurement results are output with CALCulate:MARKer:FUNCtion:POWer:RESult?
Parameter: ON: Results output referred to measurement bandwidth.
OFF: Results output in absolute values.
Example of channel/adjacent channel measurement:
"SENS2:POW:ACH:ACP 3" 'Sets the number of adjacent channels in screen B to 3.
"SENS2:POW:ACH:BAND 30KHZ" 'Sets the bandwidth of the main channel to 30 kHz.
"SENS2:POW:ACH:BAND:ACH 40KHZ" 'Sets the bandwidth of all adjacent channels to 40 kHz.
"SENS2:POW:ACH:BAND:ALT1 50KHZ" 'Sets the bandwidth of all alternate adjacent channels to
50 kHz.
"SENS2:POW:ACH:BAND:ALT2 60KHZ" 'Sets the bandwidth of alternate adjacent channel 2 to
60 kHz.
"SENS2:POW:ACH:SPAC 30KHZ" 'Sets the spacing between channel and adjacent channel
as well as between all adjacent channels to 30 kHz.
"SENS2:POW:ACH:SPAC:ALT1 40KHZ" 'Sets the spacing between adjacent channel and alternate
adjacent channel as well as between all alternate
adjacent channels to 40 kHz.
"SENS2:POW:ACH:SPAC:ALT2 50KHZ" 'Sets the spacing between alternate adjacent channel 1
and alternate adjacent channel 2 to 50 kHz.
"SENS2:POW:ACH:MODE ABS" 'Switches on absolute power measurement.
6.72 Operating Manual 1313.9681.12 - 01