R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
SELECT USER
STD
SAVE AS USER
STD
DELETE USER
STD
Analyzer Mode
The softkey SELECT USER STD selects and activates a user defined ACP standard.
After selecting the standard, the user defined atndard becomes available for selection
in the ACP standard list (USER list item). The corresponding filename is shown
in brackets.
Remote command: CALC:MARK:FUNC:POW:PRES
As of firmware version 4.4x, you can save the current ACP configuration in a file and
use it as a user defined ACP standard. The data set is stored on the instruments
harddisk in XML file format.
Softkey SAVE AS USER STD opens a dialog box to store the user defined configuration.
The following list shows the parameters that you can customize:
• Number of Adjacent Channels
• Channel Bandwidth of TX, ADJ and ALT channels
• Channel Spacings
• Resolution Bandwidth, Video Bandwidth
• ACP Limit State and ACP Limits
• Sweeptime, Sweeptime Coupling
• Detector
• Trace Mode (Clr/Write,..)
Note that the ACP User Standard is not supported for Fast ACP and Multi Carrier
ACP Measurements.
Remote command: use SENSe:POWer Subsystem to configure a
user standard
CALC:MARK:FUNC:POW:STAN:SAVE
CALC:MARK:FUNC:POW:STAN:CAT?
Opens a dialog box to delete user defined ACP standards.
Remote command: CALC:MARK:FUNC:POW:STAN:DEL
4.94 Operating Manual 1313.9681.12 - 01