R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
[SENSe:]CORRection:CVL:SELect
SENSe Subsystem
This command selects the Conversion Loss Table designated with . If is not
available, a new Conversion Loss Table will be created.
Parameter: ::= Name of Conversion Loss Table as string data with a maximum of
8 characters
Example: "CORR:CVL:SEL 'LOSS_TAB_4'"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is only available if option R&S FSU-B21 is installed.
[SENSe:]CORRection:CVL:SNUMber
This command defines the serial number of the mixer in the Conversion Loss Table. Prior to this
command, the command SENS:CORR:CVL:SEL must be sent.
Parameter: ::= Serial number of mixer with a maximum of 16 characters
Example: "CORR:CVL:SEL 'LOSS_TAB'"
"CORR:CVL:SNUM '123.4567'"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is only available with the option R&S FSU-B21.
[SENSe:]CORRection:METHod TRANsmission | REFLection
This command selects the type of measurement with active tracking generator (transmission/
reflection).
Example: "CORR:METH TRAN "
'Sets the type of measurement in screen A to “transmission“.
Characteristics: *RST value: TRANsmission
SCPI: device-specific
Mode: A
This command must be sent prior to the subsequent commands used to change/
activate the Conversion Loss files.
This command is only valid in conjunction with the ext. generator control option (B10).
6.156 Operating Manual 1313.9681.12 - 01