R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Error Messages
9.1 Introduction
Introduction
Error messages are entered in the error/event queue of the status reporting system
in the remote control mode and can be queried with the command SYSTem:
ERRor?. The answer format of R&S FSQ to the command is as follows:
, ";
"
The indication of the remote control command with prefixed semicolon is optional.
Example:
The command "TEST:COMMAND" generates the following answer to the query SYS-
Tem:ERRor?:
-113,"Undefined header;TEST:COMMAND"
The subsequent list contains the description of error texts displayed on the instrument.
Distinction is made between error messages defined by SCPI, which are marked by
negative error codes, and the device-specific error messages for which positive
error codes are used:
• 9.2“SCPI-Specific Error Messages” on page 9.3
• “Device-Specific Messages” on page 9.8
The right-hand column in the following tables contains the error text in bold which is
entered in the error/event queue and can be read out by means of query SYSTem:
ERRor?. A short explanation of the error cause is given below. The left-hand column
contains the associated error code.
9.2 Operating Manual 1313.9681.12 - 01