R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Notation
These key words mark parameters which may be entered as numeric values or be
set using specific key words (character data).
The following key words given below are permitted:
– MINimum – This key word sets the parameter to the smallest possible value.
– MAXimum – This key word sets the parameter to the largest possible value.
– DEFault – This key word is used to reset the parameter to its default value.
– UP – This key word increments the parameter value.
– DOWN – This key word decrements the parameter value.
The numeric values associated to MAXimum/MINimum/DEFault can be queried by
adding the corresponding key words to the command. They must be entered following
the quotation mark.
Example:
SENSe:FREQuency:CENTer? MAXimum
returns the maximum possible numeric value of the center frequency as result.
This key word is provided for commands the parameters of which consist of a
binary data block.
Operating Manual 1313.9681.12 - 01 6.7