R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
DISPlay Subsystem
The trace is switched off (= BLANK in manual operation) with the DISPlay[:WINDow]:
TRACe[:STATe] command.
The number of measurements for AVERage, MAXHold and MINHold is defined with the [SENSe:
]AVERage:COUNt or [SENSe:]SWEep:COUNt command.
Synchronization to the end of the indicated number of measurements is only possible in single-sweep
mode.
If calculation of average values is active, selection between logarithmic and linear averaging is
possible. For more detail see command [SENSe:]AVERage:TYPE.
Example: "INIT:CONT OFF"
'Switching to single-sweep mode.
"SWE:COUN 16"
'Sets the number of measurements to 16.
"DISP:WIND1:TRAC3:MODE MAXH"
'Switches on the calculation of the for trace 3 in screen A.
"INIT;*WAI"
'Starts the measurement and waits for the end of the 16 sweeps.
Characteristics: *RST value: WRITe for TRACe1, STATe OFF for TRACe2/3
SCPI: device-specific
Mode: A
DISPlay[:WINDow]:TRACe:MODE:HCONtinuous ON | OFF
This command specifies whether or not the traces with peak or minimum value detection are reset after
specific parameter changes.
Usually the measurement must be restarted after a parameter change, before an evaluation of the
measurement results is performed (e.g. with a marker). In cases in which a change causes a
compulsory new measurement, the trace is automatically reset in order to prevent erroneous
measurements of previous measurement results (e.g. when the span changes). For applications in
which this behavior is not desired, this mechanism can be switched off.
Parameter: OFF: The traces are reset after specific parameter changes.
ON: The reset mechanism is switched off.
Example: "DISP:WIND1:TRAC3:MODE:HCON ON"
'The reset mechanism is switched off for measurement window 1.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
DISPlay[:WINDow]:TRACe[:STATe] ON | OFF
This command switches on or off the display of the corresponding trace in the selected measurement
window.
Example: "DISP:WIND1:TRAC3 ON"
Characteristics: *RST value: ON for TRACe1, OFF for TRACe2 and 3
SCPI: conform
Mode: A
Operating Manual 1313.9681.12 - 01 6.111