R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
SENSe Subsystem
: Offset between the detection of the trigger signal and the start of
the measurement at the next frequency point.
Range of values: 0 s, 125 ns to 100s
: Gate length with Gated Sweep.
Range of values: 0 s, 125 ns to 100s
Return value: The query command returns a list of comma-separated values (CSV) of the
settings, i.e.
ON,ON,ON,IMM,POS,0,0
if the configuration has been set with the command
"SENSe:LIST:POWer:SET ON,ON,ON,IMM,POS,0,0"
Example: "SENSe:LIST:POWer:SET ON,OFF,OFF,EXT,POS,10US,434US"
"SENSe:LIST:POWer:SET ON,ON,ON,VID,NEG,10US,0"
Characteristics: *RST values: ON,OFF,OFF,IMM,POS,0S,0S
SCPI: device-specific
Mode: A
[SENSe:]LIST:POWer:SET:AVERage:TYPE LINear | LOGarithmic
With this command the average type of the sense list measurement can be set either to linear (default)
or logarithmic. In linear mode voltages are averaged in logarithmic mode levels.
Example: "LIST:POW:SET:AVER:TYPE LOG"
'sets log averaging for list measurement.
Characteristics: *RST value: LIN
SCPI: device-specific
Mode: A
[SENSe:]LIST:POWer:STATe OFF
This command deactivates the list measurement.
Example: "SENSe:LIST:POWer:STATe OFF"
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
• The value 0 s deactivates the use of GATED TRIGGER; other values activate
the GATED TRIGGER function.
• Values 0 s are only possible if is different from IMMediate.
Otherwise, an execution error is triggered.
6.180 Operating Manual 1313.9681.12 - 01