R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Parameter: ::= DOS file name
Example: "HCOP:DEV:LANG BMP"
'Selection of data format.
"HCOP:DEST 'MMEM'"
'Selection of the output device
"MMEM:NAME 'PRINT1.BMP'"
'Selection of file name.
"HCOP:IMM"
'Start of the printout.
Characteristics: *RST value: -
SCPI: conform
Mode: A
This command is an event and therefore has no *RST value and no query.
MMEMory:RDIRectory
MMEMory Subsystem
This command deletes the indicated directory. The directory name includes indication of the path and
may also include the drive name. The path name complies with DOS conventions.
Parameter: ::= DOS path name
Example: "MMEM:RDIR 'D:\TEST'"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
MMEMory:SELect[:ITEM]:ALL
This command includes all data subsets in the list device settings to be stored/loaded.
Example: "MMEM:SEL:ALL"
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value.
MMEMory:SELect[:ITEM]:DEFault
This command sets the default list of device settings to be stored/loaded. The latter includes:
• current configuration of general device parameters (general setup)
• current setting of the measurement hardware including markers
• activated limit lines
• user-defined color setting
• configuration for the hardcopy output
• activated transducers
6.138 Operating Manual 1313.9681.12 - 01