R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
TRIGger[:SEQuence]:LEVel:VIDeo 0 to 100PCT
This command sets the level of the video trigger source.
Example: "TRIG:LEV:VID 50PCT"
Characteristics: *RST value: 50 PCT
SCPI: device-specific
Mode: A
TRIGger[:SEQuence]:SLOPe POSitive | NEGative
TRIGger Subsystem
This command selects the slope of the trigger signal. The measurement starts on a positive or negative
slope of the trigger signal. The selected trigger slope applies to all trigger signal sources.
Example: "TRIG:SLOP NEG"
Characteristics: *RST value: POSitive
SCPI: conform
Characteristics: SCPI: device-specific
Mode: A
TRIGger[:SEQuence]:SOURce IMMediate | EXTernal | VIDeo | IFPower
This command selects the trigger source for the start of a sweep.
Parameter:
IMMediate Automatic triggering of the next measurement at the end of the
previous one. The value IMMediate)corresponds to the FREE RUN
setting.
EXTernal The next measurement is triggered by the signal at the external
trigger input.
VIDeo The next measurement is triggered by the detection of a signal at
the video filter output.
IFPower The next measurement is triggered by the detection of a signal at
the instrument IF (10 MHz bandwidth)
Example: "TRIG:SOUR EXT"
'Selects the external trigger input as source of the trigger signal
Characteristics: *RST value: IMMediate
SCPI: conform
Mode: A
The trigger source selection has to be done with the command TRIGger[:
SEQuence]:SYNChronize:ADJust.
The selection of trigger sources is extended by option FM Demodulator (R&S FS-
K7) (see manual for option).
This command is only available from firmware version 1.20 or higher.
6.254 Operating Manual 1313.9681.12 - 01