R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
SELECT
MARKER
Analyzer Mode
The SELECT MARKER softkey activates the numerical selection of the marker in
the data entry field. Delta marker 1 is selected by input of ' 0 '.
Remote command: CALC:MARK1 ON
CALC:MARK1:X
CALC:MARK1:Y?
PEAK The PEAK softkey sets the active marker/delta marker to the peak of the trace. If no
marker is active when MKR-> menu is called, MARKER 1 is automatically switched
on and the peak search is performed.
CENTER =
MKR FREQ
REF LEVEL =
MKR LVL
NEXT MIN
NEXT MIN RIGHT
NEXT MIN LEFT
EXCLUDE DC
EXCLUDE LO
PEAK EXCURSION
2. side menu
AUTO MAX PEAK
AUTO MIN PEAK
Remote command: CALC:MARK:MAX
CALC:DELT:MAX
The CENTER = MKR FREQ softkey sets the center frequency to the current marker
or delta marker frequency.
A signal can thus be set to the center of the frequency display range, for example,
so that it can then be examined in detail with a smaller span.
The softkey is not available in the time domain (zero span).
Remote command: CALC:MARK:FUNC:CENT
Example
A spectrum is displayed with a large span after PRESET. A signal off the center is to
be examined in detail:
[PRESET] R&S FSQ is set to the default setting.
[MKR->] MARKER 1 is switched on and automatically jumps to
the largest signal of the trace.
[CENTER=MKR FREQ] The center frequency is set to the marker frequency. The
span is adapted in such a way that the minimum frequency
(= 0 Hz) or the maximum frequency is not
exceeded.
[SPAN] The span can, for example, be reduced using the rotary
knob.
The REF LEVEL = MKR LVL softkey sets the reference level to the current marker
level.
Remote command: CALC:MARK:FUNC:REF
Operating Manual 1313.9681.12 - 01 4.73