R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Example: "CALC:MARK2:MAX"
'Positions marker 2 in screen A to the maximum value of 'the trace.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
CALCulate:MARKer:MAXimum:RIGHt
CALCulate Subsystem
This command positions the specified marker to the next smaller maximum value to the right of the
current value (i.e. in ascending X values) on the corresponding trace.
Example: "CALC:MARK2:MAX:RIGH"
'Positions marker 2 in screen A to the next lower maximum value to the right of the
current value.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
CALCulate:MARKer:MINimum:AUTO ON | OFF
This command switches an automatic minimum peak search for marker 1 at the end of each particular
sweep on and off. The current marker search limit settings (LEFT LIMIT, RIGHT LIMIT, THRESHOLD,
EXCLUDE LO) are taken into account. The numeric suffix at MARKer is irrelevant.
Example: "CALC:MARK:MIN:AUTO ON"
Activates the auto search function for marker 1.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
If no next smaller maximum value is found on the trace (level spacing to adjacent
values < peak excursion), an execution error (error code: -200) is produced.
CALCulate:MARKer:MINimum:LEFT
This command positions the specified marker to the next higher minimum value to the left of the current
value (i.e. in descending X direction) on the corresponding trace.
If no next higher minimum value is found on the trace (level spacing to adjacent
values < peak excursion), an execution error (error code: -200) is produced.
Example: "CALC:MARK2:MIN:LEFT"
'Positions marker 2 in screen A to the next higher minimum value to the left of the
current value.
6.48 Operating Manual 1313.9681.12 - 01