R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
CALCulate Subsystem
"DET RMS"
'Sets the RMS detector
"TRIG:SOUR VID;LEV:VID 50 PCT"
'Selects the trigger source VIDeo and sets the level of the video trigger source to
50 PCT
"SWE:TIME 50ms"
'Sets the sweep time to 50 ms
"INIT;*WAI"
'Starts the measurement with synchronization
"CALC:MARK:FUNC:MSUM? 50US,450US,576.9US,8"
'Queries 8 bursts with an offset of 50 µs, a test time of 450 µs and a period of
576.9 µs
Characteristics: *RST value: -
SCPI: device-specific
Mode: A-T
CALCulate:MARKer:FUNCtion:NDBDown
This command defines the level spacing of the two delta markers to the right and left of marker 1 in the
selected measurement window. Marker 1 is always used as the reference marker. The numeric suffix
is irrelevant for this command.
The temporary markers T1 and T2 are positioned by n dB below the active reference marker. The
frequency spacing of these markers can be queried with CALCulate:MARKer:FUNCtion:
NDBDown:RESult?.
If a negative value is entered than the markers are placed n dB above the active reference marker.
This is then a n dB up function which can be used for notch filter measurements:
Example: "CALC:MARK:FUNC:NDBD 3dB"
'Sets the level spacing in screen A to 3 dB.
Characteristics: *RST value: 6dB
SCPI: device-specific
Mode: A
CALCulate:MARKer:FUNCtion:NDBDown:FREQuency?
This command queries the two frequencies of the N-dB-down marker in the selected measurement
window. The numeric suffix is irrelevant for this command. The two frequency values are
separated by comma and output in ascending order.
A complete sweep with synchronization to sweep end must be performed between switching on the
function and querying the measured value to obtain a valid query result. This is only possible in singlesweep
mode.
Example: "INIT:CONT OFF"
'Switches to single-sweep mode.
"CALC:MARK:FUNC:NDBD ON"
'Switches on the n-dB-down function in screen A.
"INIT;*WAI"
'Starts a sweep and waits for the end.
6.58 Operating Manual 1313.9681.12 - 01