R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
[SENSe:]LIST:RANGe:INPut:ATTenuation:AUTO ON | OFF
This command switches the autoranging of a range in the spurious measurement on or off.
Example: "LIST:RANG2:INP:ATT:AUTO ON"
'Activates autorange for range 2
Characteristics: *RST value: ON
SCPI: device-specific
Mode: A
[SENSe:]LIST:RANGe:INPut:GAIN:STATe ON | OFF
This command switches the preamplifier of a range in the spurious measurement on or off.
Example: "LIST:RANG2:INP:GAIN:STAT ON"
'Activates the preamplifier for range 2
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
[SENSe:]LIST:RANGe:LIMit -200dB to +200dB
SENSe Subsystem
This command defines the limit lines for the spurious emission measurement list evaluation (for details
on this measurement see “LIST EVALUATION” on page 4.131). For each of the 20 ranges, you can
specify a limit line via the numeric suffix at RANGe. The numeric suffix at SENSe is
irrelevant.
Example: "LIST:RANG5:LIM -40"
’Limit line in range 5 is –40 dB.
Characteristics: *RST value: -13dB
SCPI: device-specific
Mode: A
[SENSe:]LIST:RANGe:LIMit:STATe ON | OFF
This command activates/deactivates the limit checking for the spurious emission measurement list
evaluation (for details on this measurement see “LIST EVALUATION” on page 4.131).
The numeric suffix at SENSe and the numeric suffix at RANGe1...20> are irrelevant.
Example: "LIST:RANG5:LIM -40"
’Limit line in range 5 is –40 dB.
"LIST:RANG7:LIM -20"
’Limit line in range 7 is–20 dB.
"LIST:RANG:LIM:STAT ON"
’Activates the limit checking in all ranges.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
Operating Manual 1313.9681.12 - 01 6.183