R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
6.5.6.3 CALCulate:MARKer:FUNCtion:FPEaks Subsystem
CALCulate Subsystem
The CALCulate:MARKer:FUNCtion:FPEaks subsystem controls the marker peak list and its functions.
CALCulate:MARKer:FUNCtion:FPEaks:ANNotation:LABel[:STATe] ON | OFF
This command activates and deactivates the peak list marker label.
Note that the peak list marker symbols have to active in order for the labels to appear. You can activate
them with CALCulate:MARKer:FUNCtion:FPEaks:ANNotation:MARKer[:STATe].
The numeric suffix at MARKer is irrelevant.
Example: "INIT:CONT OFF"
'activates single sweep mode.
"CALC:MARK:FUNC:FPE ON"
'turns the peak list on.
"CALC:MARK:FUNC:FPE:SEAR:AUTO ON"
'makes the R&S FSQ perform a peak search after the sweep.
"CALC:MARK:FUNC:FPE:LIST:SIZE 5"
'adds five peaks to the list.
"CALC:MARK:FUNC:FPE:SORT Y"
'sorts the list by y values in decreasing order.
"CALC:MARK:FUNC:FPE:ANN:MARK ON"
'activates peak list markers.
"CALC:MARK:FUNC:FPE:ANN:LAB ON"
'activates peak list marker labels.
"INIT;*WAI"
'starts the measurement and synchronizes to end.
"CALC:MARK:FUNC:FPE:COUN?"
'returns the number of detected peaks.
"CALC:MARK:FUNK:FPE:Y?"
'returns the level of the peaks,
e.g. '-37.5,-58.3,-59.6'.
"CALC:MARK:FUNC:FPE:X?"
'returns the horizontal position of the peaks,
'e.g. '107.5E6, 153.8E6, 187,9E6'.
"TRAC? FPE"
'returns the peak list.
Characteristics: *RST value: ON
SCPI: device-specific
Mode: A
Operating Manual 1313.9681.12 - 01 6.63