Complete Compiled Specification.pdf - Peck Ormsby Construction

3) The Contractor shall make neat and legible notations on the record drawings
progress sheets daily as the work proceeds, showing the work as actually
installed. For example, should a piece of equipment be installed in a
location that does not match the plan, the Contractor must indicate that
equipment has been relocated in a graphic manner so as to match the
original symbols as indicated in the irrigation legend. The relocated
equipment and dimensions will then be transferred to the original record
drawing plan at the proper time.
4) Before the date of the final inspection, the Contractor shall transfer all
information from the "as-built" prints to an ozalid sepia, procured from the
Owner's Authorized Representative. All work shall be in waterproof India ink and
applied to the mylar by a technical pen made expressly for use on mylar material.
Such pen shall be similar to those manufactured by Rapidograph, Kueffell & Esser, or
Faber Castell. The dimensions shall be made so as to be easily readable even on
the final controller chart (see Section ?). The original mylar "record drawing" plan
shall be submitted to the Owner's Authorized Representative for approval of prior to
fabricating the controller chart.
5) The Contractor shall dimension from two (2) permanent points of reference,
building corners, sidewalk or road intersections, etc., the location of the
following items:
a. Connection to existing water lines.
b. Connection to existing electrical power.
c. Gate valves.
d. Routing of sprinkler pressure lines (dimensions max. 100' along
routing).
e. Electric control valves.
f. Routing of control wiring.
g. Quick coupling valves.
h. Other related equipment as directed by the Owner's Authorized
Representative.
6) On or before the date of the final inspection, the Contractor shall deliver the
corrected and completed sepias to the Owner's Authorized Representative.
Delivery of the sepias will not relieve the Contractor of the responsibility of furnishing
required information that may be omitted from the prints.
C. Equipment to be Furnished:
1) Supply as part of this contract the following:
a. Two (2) keys for each controller.
2) The above mentioned equipment shall be turned over to the Owner at the
conclusion of the project. Before final observation can occur, evidence that
the Owner has received these items must be shown to the Owner's
Authorized Representative.
1.05 PRODUCT DELIVERY, STORAGE AND HANDLING
A. Handling of PVC Pipe and Fittings:
The Contractor is cautioned to exercise care in handling, loading, unloading, and
storing of PVC pipe and fittings. All PVC pipe shall be transported in a vehicle which
allows the length of pipe to lie flat so as not to subject it to undue bending or
concentrated external load at any point. Any section of pipe that has been dented or
damaged will be discarded and, if installed, shall be replaced with new piping.
________________________________________________________________________
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
UNDERGROUND IRRIGATION SYSTEMS 02810-3