Complete Compiled Specification.pdf - Peck Ormsby Construction

3.02 WORKMANSHIP
A. All work shall be shop fabricated to required profiles by forming and welding with corners,
angles and edges straight and sharp. Fit and fabricate accurately with corners, joints, seams
and surfaces free from warp, wave, buckle, or other defects.
3.03 SHOP PAINTING
A. All exposed surfaces not galvanized shall be cleaned, bonderized, and given one baked-on
shop coat of gray synthetic primer. Paint back surfaces of frames in masonry walls with
heavy bodied bituminous paint.
3.04 INSTALLATION OF METAL FRAMES
A. Install plumb, straight, true, and rigidly secured in place. Frames shall be properly braced
until anchored to final support. Provide temporary spreaders.
B. Frames shall be anchored to concrete floors with powder actuated bolts.
C. Frames in masonry shall be filled solid with grout.
3.05 INSTALLATION OF DOORS
A. Fit metal doors accurately in their respective frames. Check and readjust operating finish
hardware on metal doors just prior to final inspection. Leave work in complete and proper
operating condition.
B. Fire rated doors shall be installed with clearances as specified in NFPA pamphlet No. 80 and
requirements of Fire Marshal having jurisdiction.
C. Immediately after erection, sand smooth any rusted or damaged areas of prime coat and
apply touchup of compatible air drying primer.
3.06 CLEANUP
A. Refer to Section 01700.
END OF SECTION
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
HOLLOW METAL DOORS AND FRAMES 08100-3