Complete Compiled Specification.pdf - Peck Ormsby Construction

SECTION 09250 - GYPSUM BOARD ASSEMBLIES
PART 1 - GENERAL
1.01 SUMMARY
A. This Section includes the following:
1. Non-load bearing steel framing members for gypsum board assemblies.
2. Gypsum board assemblies attached to steel framing.
3. Cementitious baker units installed at all toilet room walls.
4. Sound attenuation batt insulation.
B. Related Documents
1. Refer to Division 6 Section “Rough Carpentry” for backing and blocking.
2. Division 9 Section “Tile” for glazed wall tile installed on cementitious backer units.
3. Division 7 Section “Joint Sealants” for acoustical sealants.
1.02 SHOP DRAWINGS
A. Refer to section 01300.
B. Manufacturer’s specifications.
1.03 QUALITY ASSURANCE
A. Coordinate with trades whose work connects with, is affected by, or is concealed by drywall.
Before proceeding with work, make certain all required inspections have been made.
B. Standards:
1. Comply with all applicable requirements of "American Standard Specifications for the
Application and Finishing of Gypsum Wallboard", by the American Standard
Association except where more stringent requirements are called for herein, local
codes, or by manufacturer. Do all cutting and patching required to accommodate
other trades.
1.04 DELIVERY AND STORAGE
A. Store materials off ground and cover against weather. Remove any damaged materials from
the site.
PART 2 - PRODUCTS
2.01 MANUFACTURERS
A. Available Manufacturers: Subject to compliance with requirements, manufacturers offering
products that may be incorporated in the Work include, but are not limited to the following:
1. Steel Framing and Furring:
a. Dale Industries, Inc.
b. Dietrich Industries, Inc.
c. Gold Bond Building Products Div., National Gypsum Co.
2. Gypsum Boad:
a. Domtar Gypsum.
b. Georgia-Pacific Corp.
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
GYPSUM BOARD ASSEMBLIES 09250-1