Complete Compiled Specification.pdf - Peck Ormsby Construction

SECTION 07900 - JOINT SEALANTS
PART 1 - GENERAL
1.01 RELATED DOCUMENTS
A. Drawings and general provisions of Contract, including General and Supplementary conditions
and Division 1 Specification Sections, apply to this Section.
1.02 SUMMARY
A. This section includes joint sealants for the following locations:
1. Exterior Vertical Building Joints: Joints and cracks around window, aluminum
entrances, door frames, columns, louvers, wall penetrations, connections, both sides
and other joints necessary to seal off building from outside air and moisture. Perimeter
edges of exterior insulation and finish system.
2. Exterior Horizontal Surfaces.
a. Sidewalk/pavement joints.
b. Other joints as indicated.
3. Interior Vertical and Horizontal Building Joints:
a. Joints and cracks around wall, ceiling, and floor penetrations.
b. Both sides of exterior and interior hollow metal door frames.
c. Inside corners of gypsum board, fiber-reinforced wall sheathing and masonry.
d. Perimeter joints of toilet fixtures.
e. All transitions between differing building materials.
f. Other joints as indicated.
B. Related Sections: The following Sections contain requirements that relate to this Section:
1. Division 7 Section “Exterior Insulation and Finish Systems” for sealing system joints.
2. Division 7 Section “Flashing and Sheet Metal” for sealing joints related to flashing and
sheet metal for roofing.
3. Division 7 Section “Firestopping” for through-penetration firestopping systems.
4. Division 7 Section “Built-Up Asphalt Roofing.”
5. Division 7 Section “Polyvinyl-Chloride (PVC) Roofing.”
6. Division 8 Section “Hollow Metal Doors and Frames.”
7. Division 8 Section “Aluminum Entrances and Storefronts.”
8. Division 8 Section “Glass and Glazing” for sealants used in glazing.
9. Division 8 Section “Insulated Translucent Sandwich Panel Wall/Roof System.”
10. Division 9 Section “Gypsum Board Assemblies” for sealing concealed perimeter joints
of gypsum board partitions to reduce sound transmission.
1.03 SYSTEM PERFORMANCE REQUIREMENTS
A. Provide joint sealants for interior applications that have been produced and installed to
establish and maintain airtight continuous seals that are water resistant and cause no staining
or deterioration of joint substrates.
1.04 SUBMITTALS
A. General: Submit the following in accordance with Conditions of Contract and Division 1
Specification Sections.
B. Product data from manufacturers for each joint sealant product required.
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
JOINT SEALANTS 07900-1