Complete Compiled Specification.pdf - Peck Ormsby Construction

SECTION 16475 – MOTOR CONTROLLERS
PART 1 - GENERAL
1.1 WORK INCLUDED:
A. Extent of motor controller and starter work is indicated by drawings, schedules and specified
herein.
B. Work includes the complete installation, electrical connections, testing, and commissioning of
starters and combination disconnect/starters.
C. Verify compatibility of motor controllers and starters with motors supplied under Division 15.
Review Division 15 specifications, plans, schedules, etc., to issue compatibility.
1.2 QUALITY ASSURANCE:
Comply with NEC, and NEMA Standards as applicable to wiring methods, construction and
installation of motor controllers, starters, and combination disconnects/starters. Provide complete
packaged units which have been UL-listed and labeled by Underwriters Laboratory or ETL Testing
Laboratories, Inc. Note: The entire unit shall carry the label, not just components.
1.3 SUBMITTALS:
A. Submit complete and descriptive shop drawings indicating dimensions and compliance with
the specifications herein. Submit manufacturer's installation instructions under provisions of
general conditions.
B. Submit dimensions of all units.
C. Equipment list and ratings: list motors to be controlled, with motor identification, function and
location, starter characteristics, size, voltage, phase and current ratings, control equipment
and accessories as specified, scheduled or noted.
D. Coordinate all motor starter sizes and requirements with Division 15 Contractor prior to
submittal for approval.
PART 2 - PRODUCTS
2.1 ACCEPTABLE MANUFACTURERS
A. MOTOR CONTROL CENTER COMBINATION STARTERS APPROVED
MANUFACTURERS: Subject to compliance with requirements, provide products
manufactured by the following manufacturer:
Square D
GE
Siemens
Cutler Hammer
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION March 2, 2009
MOTOR CONTROLLERS Section 16475-1