Complete Compiled Specification.pdf - Peck Ormsby Construction

SECTION 07411 - MANUFACTURED ROOF PANELS
PART 1 - GENERAL
1.01 DESCRIPTION OF WORK
A. Furnish and install un-insulated metal roof panels as shown and noted on drawings.
B. Related Sections:
1. Division 5 Section “Structural Steel.”
2. Division 5 Section “Steel Joists and Joist Girders.”
3. Division 5 Section “Steel Deck.”
4. Division 7 Section “Building Insulation.”
5. Division 7 Section “Flashing and Sheet Metal.”
1.03 QUALITY ASSURANCE
A. Manufacturer and erector shall demonstrate a minimum of five years of related industry
experience.
B. Profile and gauges of panels shall beet a wind load of 70 MPH for panels without exceeding a
deflection of L/180.
1.04 SUBMITTALS
A. No less than ten days prior to bid date, submit all independent laboratory test reports, design
and performance data as specified.
B. Prior to fabrication, submit erection/shop drawings for products specified, showing all erection
procedures and accessories required.
C. Refer to Section 01300.
PART 2 - PRODUCTS
2.01 MANUFACTURERS
A. Available Manufacturers: Subject to compliance with requirements, manufacturers offering
products that may be incorporated in the Work include, but are not limited to the following:
1. Berridge Manufacturing co.
2. BHP Steel Building Products USA
3. AMP, Atlanta Metal Products, Inc.
4. Copper Sales, Inc. UNA-CLAD
5. MBCI
2.02 MATERIALS
A. 24 gauge, standing seam 12” o.c. continuous roll-formed panels, similar to MBCI LokSeam
system.
B. The flashing and trim shall be of the same material, gauge, finish and color(s) as the panels,
unless otherwise indicated.
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2,2009
MANUFACTURED ROOF PANELS 07411 - 1