Complete Compiled Specification.pdf - Peck Ormsby Construction

Power factor equal to or greater than 95%.
Lamp starting at any light output setting.
Meet all current Federal, State and Power Co. efficiency and efficacy standards, and
rebate program requirements.
Meet all current ANSI, IEEE, and FCC regulations for EMI/RFI, harmonic distortion,
and transient protection.
Provide normal lamp life as stated by lamp manufacturer.
Minimum 5 year ballast and replacement labor warranty by manufacturer.
Ballast manufacturer's data must be included with lighting fixture submittals.
Compatible with occupancy sensor switching.
Approved manufacturers: Advance (Mark 10), Lutron, or approved.
Coordinate dimming ballasts with dimming controls specified in separate section.
F. STANDARD COMPACT FLUORESCENT BALLASTS – PROGRAMMED START: Compact
fluorescent ballasts, unless noted otherwise on Light Fixture Schedule, shall be programmed
start electronic type; to operate 4 pin compact fluorescent lamps, ballast data as follows:
UL listed and CSA certified.
Full light output.
Dual voltage rated 120/277
Capable of operating more than one lamp wattage for PL-T triple tube applications
Recognized Testing Laboratory listed, thermally protected, resetting, non-PCB,
sound rated A.
Operate lamp(s) at a frequency of above 40 kHz.
Total Harmonic Distortion (THD) of less than 10%.
Programmed start.
Power factor equal to or greater than 98%.
Maximum lamp crest factor 1.7.
Minimum lamp starting temperature of 0 degrees F.
Meet all current Federal, State and Power Company efficiency and efficacy
standards, and rebate program requirements.
Meet all current ANSI, IEE, and FCC regulations for EMI/RFI, harmonic distortion,
and transient protection.
Provide normal lamp life as stated by lamp manufacturer.
Minimum 5 year ballast and replacement labor warranty by manufacturer.
End-of-life detection and shut-down circuitry that meets proposed ANSI/IEC
standards.
Ballast manufacturer's data must be included with light fixture submittal.
Approved manufacturers: Advance, Osram Sylvania, Magnetek, Howard Industries, or
approved.
G. HID ballasts shall be as follows:
1. Metal Halide (MH):
a. High power factor, normal ambient, 180 degrees C insulation class.
b. Auto transformer with capacitor and ignitor for lamps 150 watt or less.
c. Constant wattage autotransformer with capacitor for lamps above 150 watts.
2. Pulse Start Metal Halide (PSMH):
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION March 2, 2009
LIGHTING Section 16500-3