Complete Compiled Specification.pdf - Peck Ormsby Construction

SECTION 02830 - FENCES AND GATES
PART 1 - GENERAL
1.01 SUMMARY
A. Section includes fence fabric, frames, gates, anchorage devices and required appurtenances
for permanent fencing as shown on drawings and specified herein.
B. Refer to Division 3 Section “Concrete Work” for concrete.
C. Temporary fencing to be provided as noted on drawings and specified herein.
1.02 SUBMITTALS
A. Refer to Division 1 Section “Submittals” for general requirements.
B. Submit shop drawings showing layouts, materials size and gage, methods of construction,
and installation, including sizes and types of all fastening devices.
C. Submit manufacturer's installation instructions.
1.03 QUALITY ASSURANCE
A. Verify all dimensions by taking field measurements; proper fit and attachment of all items is
required.
1.04 DELIVERY AND STORAGE
A. Deliver and store materials in dry, protected areas. Protect from rusting and other damage.
Store on wood blocks. Remove any damaged items from site and replace at no additional
cost to the Owner.
PART 2 - PRODUCTS
2.01 MATERIALS
A. Chain link fabric:
1. Steel core wire shall be galvanized in accordance with ASTM A-641-71 A. Mesh type
to be standard industrial 2" mesh 9 gauge.
a. Selvage: Knuckled at top and bottom selvage.
B. Posts, Top Rails, Braces:
1. Galvanized steel pipe, ASTM A-120, standard weight.
2. End, corner and pull posts: 2.875-inch OD steel pipe
3. Line or Intermediate posts: 2.375-inch OD pipe.
4. Rails: 1.625-inch OD pipe.
5. Gate Posts:
a. Gates up to 4’-0”: 2.875-inch OD pipe.
b. Gates over 4’-0”: 4.0-inch OD Type II steel pipe.
6. Post braces and truss rods: At each gate, corner, pull, or end post. Provide with
turnbuckles for adjustment.
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
FENCES AND GATES 02830 - 1