Complete Compiled Specification.pdf - Peck Ormsby Construction

Division 1500-S-4 - Finish System Standards. Factory finish to be water based stain and
ultraviolet (UV) cured polyurethane sealer to comply with EPA Title 5 guidelines for Volatile
Organic Compounds (VOC) emissions limitations.
1. Performance Standard: TR-6 catalyzed polyurethane.
2. Color: Clear
B. Install factory finished doors just prior to substantial completion.
PART 3 - EXECUTION
3.01 INSTALLATION
A. Hang doors in adequately secured, square and plumb frames with clearances of not more
than 3/32" at each side and head; clearance at bottom 1/2" or as required for floor finish.
B. Install storage room doors in accordance with NFPA pamphlet No. 80.
3.02 INSTALLATION OF DOORS
A. Assemble and set all doors. Attach all subframes and special anchors. Fit all doors accurately
to their frames with even margin at top and jambs and with proper clearance at threshold.
Remove and reset doors and hardware for the installation of work of other trades.
B. Trim non-rated door width by cutting equally on both jamb edges.
C. Trim door height by cutting bottom edges to a maximum 3/4 inch.
D. Trim fire door height at bottom edge only, in accordance with fire rating requirements.
E. Pilot drill screw and bolt holes using templates provided by hardware manufacturer.
F. Coordinate installation of doors with installation of frames and hardware
G. Coordinate installation of glass and glazing.
H. Reseal or refinish any doors that required site alteration.
3.03 WARRANTY TOLERANCES
A. Conform to WDMA standards and testing methods for warp, cup, bow and telegraphing.
3.04 ADJUSTING
A. Adjust work under provisions Division 1.
B. Adjust doors for smooth and balanced door movement.
3.05 CLEANUP
A. Refer to Section 01700.
B. Hardware shall be thoroughly cleaned. Care shall be taken to protect doors and hardware
until completion of Work.
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2,2009
WOOD DOORS 08200 - 3