Complete Compiled Specification.pdf - Peck Ormsby Construction

1.06 PROJECT CONDITIONS
A. Field Measurements: Verify dimensions in system installation areas and indicate if
dimensions on shop drawings are actual or guaranteed dimensions.
1.07 WARRANTY
A. General Warranty: Any warranties specified in this section shall not alter or change Owners
rights and provisions received under other contract documents, and shall be in addition to
those documents.
B. Special Warranty: Provide system manufacturer provide written agreement to repair or
replace all defective panel and system craftsmanship for a period of one (1) year from date of
substantial completion. Provide Installer’s warranty against leakage for one (1) year from date
of substantial completion.
1.08 PRODUCT HANDLING
A. Store panels on long edge, several inches above the ground, blocked and under cover to
prevent damage. Follow manufacturer’s storage and handling instructions.
PART 2 - PRODUCTS
2.01 MANUFACTURERS
A. Available Manufacturers: Subject to compliance with requirements, manufacturers offering
products that may be incorporated in the Work include, but are not limited to the following:
1. Kalwall Corporation.
B. Manufacturers wishing to bid this section must submit product information showing all
compliance including IBC compliance in accordance with the ICBO reports and receive
written approval prior to bidding.
2.02 MATERIALS AND PANEL FABRICATION
A. Translucent Fiberglass Faces: Manufactured from glass fiber reinforced thermoset resins by
insulated system fabricator especially for architectural use. Thermoplastic (e.g.
polycarbonate, acrylic) faces are not acceptable.
B. Flammability: The interior face sheet shall be UL listed and have a flamespread rating no
greater than 45 and smoke developed no greater than 350 when tested in accordance with
UL 723. Burn extent by ASTM D-635 shall be no greater than 1". Faces shall not deform,
deflect, drip when subject to fire or flame, or become detached when subjected to 300
degrees F for 25 minutes.
C. Weatherability: The full thickness of the exterior face shall not change color more than 3.0
Hunter of CIE Units DELTA E by ASTM D-2244 after five (5) years outdoor South Florida
weathering at 5 degrees facing south, determined by the average of at least three (3) white
samples with and without a protective film or coating to insure maximum, long-term color
stability.
1. Class A Roof System: Seven (7) Units, after 30 months exposure.
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION
INSULATED TRANSLUCENT SANDWICH PANEL WALL/ROOF SYSTEM 08950 - 3