Complete Compiled Specification.pdf - Peck Ormsby Construction

1.05 DELIVERY AND STORAGE
A. Frames and doors shall be stored in an upright position, under cover, and protect from extreme
change in temperature and humidity. Avoid creating a humidity chamber by using a plastic or
canvas shelter and by not venting the area covered. Remove any damaged items from site and
replace at no additional cost to Owner.
B. All doors and frames shall be provided by one manufacturer.
C. Ship materials to job site in separate containers with identified building locations.
1.06 MANUFACTURER
A. Available Manufacturers: Subject to compliance with requirements, manufacturers offering
products that may be incorporated in the Work include, but are not limited to the following:
1. Kawneer Corporation
2. Amarlite
3. Arcadia
4. U.S. Aluminum
5. Vistawall
PART 2 - PRODUCTS
2.01 ALUMINUM DOORS
A. All doors and framing sections shall be extruded from 6063-T5 aluminum alloy. All major door
sections shall maintain at least 1/8" wall section thickness. Fasteners shall be non corrosive.
B. All exposed surfaces shall be free from defects, die marks or scratches.
C. Doors shall be wide stiles with minimum widths as indicated below, and shall be securely joined
by means of structural corner assemblies. Welded corners without structural reinforcement will
not be permitted. Vertical rails shall overlap and conceal the corner joint. Lock and hinge stiles of
single acting doors shall be beveled. Doors shall be adjusted vertically. Glass stops shall be
snap-on type with non-stretch vinyl beads.
1. Top Rail: 4-1/2 inches.
2. Stiles: 5-1/2 inches.
3. Bottom Rail: 10 inches.
2.02 ALUMINUM FRAMES
A. Aluminum framing members shall be 2" deep by approximately 4" wide, unless shown otherwise,
extruded from 6063-T5 alloy. Glass framing members shall provide a flush glazed appearance on
all sides. Fasteners shall be non-corrosive. Non-stretch, high shore vinyl shall be provided at both
sides of the glass.
B. Exposed surfaces shall be free of defects, die marks or scratches.
C. Fabrication shall be accurately done so final assembly will be neat, tightly fitted joints.
2.03 FINISHES
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
ALUMINUM ENTRANCES AND STOREFRONTS 08400 - 2