Complete Compiled Specification.pdf - Peck Ormsby Construction

2. Chain bolts are 3" long, and have an 18" pull and an angle strike to secure inactive
door on cabinets over 72" in height. Elbow catches are used on inactive doors up to
and including 72" in height.
G. Coat Rods:
1. 1" diameter, 14-gauge chrome plated steel installed in captive mounting hardware.
H. Drawer Accessories:
1. Standard Hanging File: PVC rails fitted to top of drawer sides. Available for Pendaflex
files. Rails are color matched to cabinet interior.
I. Mirrors:
1. I/4" thick polished mirror plate.
J. Grommets for power chord and cable passage: At each power and data outlet below
countertops, provide 3" diameter hole with molded plastic cover. (Color as selected by
Architect). Cabinet installer to coordinate with electrical and other trades as needed.
2.05 FABRICATION
A. Fabricate casework, countertops and related products to dimensions, profiles, and details
shown.
B. Comply with accessibility requirements, including, but not limited to ANSI A117.1. At sink
units, do not provide bottom shelf and provide toe kick integral with cabinet door for wheel
chair access.
C. Cabinet Body Construction:
1. Tops and bottoms are joined to cabinet ends and internal cabinet components such
as fixed horizontals, rails and verticals using 10mm diameter industrial grade
hardwood dowels, laterally fluted with chamfered ends, securely glued and clamped
under pressure during assembly to secure joints and cabinet squareness. A minimum
of six (6) dowels at each joint for 24" deep cabinets and la minimum of four (4)
dowels at each joint for 12" deep cabinets are used.
2. Unless specifically indicated, core 3/4" thick particleboard. Edging and surface
finishes as indicated herein.
3. Unit backs on fixed cabinetry shall be 1/2" thick particleboard, and on relocatable
cabinetry backs shall be 3/4" thick particleboard structurally doweled into cabinet end
and top panels, color matched to cabinet interior. Exposed backs on fixed or movable
cabinets to be 3/4" thick particleboard, color matched to cabinet interior, exterior
surface GP28 laminate as selected.
4. All fixed undercounter and tall units have an individual factory applied base,
constructed of 3/4" A.C. Grade plywood. Base is 96mm (nominal 4") high unless
otherwise indicated on the drawings.
5. All base units, except sink base units, are provided with a full sub-top. Sink base
units are provided with open top, a welded steel/epoxy painted sink rail full width at
top front edge concealed behind face rail/doors, a split back removable access panel,
and bottom panel to have CL20 high pressure cabinet liner, color to match interior
color. No exceptions will be permitted.
6. All end panels and vertical dividers are prepared to receive adjustable shelf hardware
at 32mm (approximately 1-1/4") line boring centers. Door hinges, drawer slides and
pullout shelves mount in the line boring to assure consistent alignment of
components.
7. All exposed and semi exposed edges of basic cabinet components are factory edged
with PVC banding, machine applied with waterproof hot melt adhesive.
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2,2009
INTERIOR ARCHITECTURAL MILLWORK 06402 - 5