Complete Compiled Specification.pdf - Peck Ormsby Construction

covered by these specifications.
Should the drawings conflict with the code, the code shall govern the proper installation of the work, and no extra
charge shall be made for the proper installation.
Should the contractor perform any work that does not comply with the requirements of the applicable building
codes, state laws, local ordinances, industry standards, or utility company regulations, he shall bear all costs
associated with correcting the deficiencies.
Where the work required by the drawings and specifications exceeds the minimum code requirements, the work
shall be done as shown or specified.
NOTE: Code compliance, or similar terminology, shall be interpreted to mean "the interpretation of the code as
enforced by the local building authority".
DRAWINGS AND SPECIFICATIONS:
These specifications are intended to cover all labor, material, and standards of mechanical workmanship to be
employed in the work shown on the drawings, called for in these specifications, or reasonably implied by terms
of same.
The drawings and specifications are intended to supplement one another, and any part of the work that may be
mentioned in the one and not represented in the other shall be done the same as if it had been mentioned or
represented in both.
Large scale drawings shall take precedence over layouts and small scale details.
The mechanical drawings are schematic in nature. They show the general arrangement of all piping, ductwork,
mechanical equipment, and appurtenances. They shall be followed as closely as the actual building
construction and the work of other trades will permit.
Due to tight structural conditions and space limitations in selected areas the contractor should anticipate
structural and space conflicts, and shall make allowances for them in his bid. Until the steel fabrication shop
drawings are submitted for review, the mechanical coordination cannot be completed.
Because of the small scale of the mechanical drawings, it is not possible to indicate all offsets, fittings, and
accessories which will actually be required. This contractor shall investigate the structural and finish conditions
affecting the work and provide all necessary offsets, fittings, valves, trim and accessories required to meet actual
job-site conditions.
a. Dimensions -
Verify dimensions governing mechanical work at the building. No extra compensation shall be claimed
or allowed on account of differences between the actual job-site dimensions and those indicated on the
drawings.
b. Adjoining work -
Examine all adjoining work on which the mechanical work is dependent and report any work which must
_________________________________________________________________________________________
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION March 2, 2009
GENERAL PROVISIONS 15010-2