Complete Compiled Specification.pdf - Peck Ormsby Construction

VALVE IDENTIFICATION CHART
NUMBER DESCRIPTION LOCATION NORMAL
POSITION
1. Cold Water Supply to Water Heater Mech. Room #121 Open
2. Cold Water Supply to Hose Room #13 Open
3. Cold Water Supply to Equip. in Room
#12
Room #18 Open
4. Sprinkling System Drain Valve Tunnel Below Room #115 Closed
5. Hot Water Supply to Toilet Room
#212
6. Air Vents - Cooling Coil #12 (2
required)
7. Heating Hot Water Balancing Valve
(Southwest Zone)
Mechanical Equipment & Ductwork:
Chase #210 Open
Fan Room 3122 Closed
Above Ceiling Room #412 Marked On
Valve
All mechanical equipment, including meters, fans, pumps, relocated equipment, and other devices shall be
identified with signs made of laminated plastic 1/8" or larger engraved letters. Signs shall be securely attached
by rustproof screws or some other permanent means (no adhesives).
Information on sign shall include name of equipment, rating, maintenance instructions, and any other important
data not included on factory attached nameplate.
Signs shall be attached to equipment so they can be easily read.
Identify all ducts exposed in mechanical equipment rooms and in ducts and pipe chases. Sample duct
identification shall be as follows:
"Cold Duct - High Pressure - To Second Floor System"
"Exhaust Duct - Toilet Room - To EF-3"
"Ventilation Air Duct - To Utility Room #228"
Ducts shall be labeled at all wall penetrations and at connections to equipment.
PAINTING:
Mechanical Contractor: All equipment which is to be furnished in factory prefinished conditions by the
______________________________________________________________________________________
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDTION March 2, 2009
BASIC MATERIALS & METHODS 15050-23