Complete Compiled Specification.pdf - Peck Ormsby Construction

a. Color and pattern as selected by architect from standard colors or from
approved equals.
2. Finish Thickness:
a. Doors shall be 3/4".
b. Panels shall be 1/2".
c. Pilasters shall be 3/4".
B. Hardware:
1. All hardware to be Heavy Duty Cast Stainless Steel.
2. All hardware shall be concealed inside compartments with the exception of outswinging
doors.
3. To include vandal resistant through-bolt mounting screws throughout.
4. Hardware of chrome plated "Zamac" is unacceptable.
C. Latch:
1. Sliding door latch shall be Heavy Duty Cast Stainless Steel surface mounted.
2. Sliding door latch shall require less than 5 lb. force to operate. Twisting latch
operation will not be acceptable.
3. Latch track shall be attached to door by theft resistant stainless steel through-bolts.
4. Latch shall allow door to be lifted over Heavy Duty Cast Stainless Steel keeper for
emergency access.
5. Metal to metal connection shall withstand a direct pull of over 1000 lbs. per screw.
6. Strike shall be Heavy Duty Cast Stainless Steel surface mounted with integral rubber
bumper door stop. Surface mounted and through bolted to partition.
D. Hinges:
1. Hinge shall be 16-gauge continuous piano hinge with 3/16" pin.
2. Outswinging and inswing door shall be equipped with self-closing 16-gauge
continuous piano hinge.
3. Continuous piano hinge shall be attached to door and stile by theft-resistant,
stainless steel through-bolts from inside and outside of compartments.
E. Coat Hook: Heavy Duty, Cast Stainless Steel coat hook shall project no more than 1-1/8"
from face of door and shall be secured by theft resistant through-bolt stainless steel screws.
Provide on all doors.
F. Door stop: Stainless steel with rubber-tipped bumper.
G. Continuous Brackets: Full high extruded aluminum 6063-T5 bright anodized finish min. 1.685
lbs. per LF, of size (thickness) to match pilasters and/or panels. Shall be mounted inside
compartment. Use for each pilaster to wall connections, pilaster to panel, and panel to wall
connections.
H. Leveling device: 3/8" x 1" steel bar shall be chromate treated and double zinc plated; bolted
to base of solid phenolic stile.
I. Stile shoe: One piece, 4" high, type 304, 18gauge stainless steel with satin finish. Top shall
have 90 degrees return to stile, attached with stainless steel through-bolts.
J. Headrail (Overhead braced): Heavy Duty extruded clear anodized aluminum continuous
headrail with anti-grip profile and integral reinforcing channel and curtain track.
2.03 FABRICATION
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
SOLID PHENOLIC PLASTIC TOILET COMPARTMENTS 10170 - 3