Complete Compiled Specification.pdf - Peck Ormsby Construction

SECTION 08800 - GLASS AND GLAZING
PART 1 - GENERAL
1.01 RELATED DOCUMENTS
A. Drawings and general provisions of the Contract, including General and Supplementary
Conditions and Division 1 Specification Sections, apply to this Section.
1.02 SUMMARY
A. This section includes glazing for the following products, including those specified in other
Sections where glazing requirements are specified by reference to this Section:
1. Door vision lites.
2. Fixed windows.
3. Storefronts.
1.03 DEFINITIONS
A. Manufacturer is used in this Section to refer to a firm that produces primary glass or
fabricated glass as defined in the referenced glazing standard.
B. Deterioration of Insulating Glass: Failure of the hermetic seal under normal use due to
causes other than glass breakage and improper practices for maintaining, and cleaning
insulating glass. Evidence of failure is the obstruction of vision by dust, moisture, or film on
the interior surfaces of glass. Improper practices for maintaining and cleaning glass do not
comply with the manufacturer’s directions.
1.04 SAMPLES
A. Refer to Section 01300. Submit manufacturer's technical data of each type of glazing
specified including installation and maintenance instructions.
B. As requested by the Architect and for verification purposes, submit 12" square samples of
each type of glass specified.
C. Submit certificates from manufacturers attesting that glass and glazing materials comply with
requirements. Separate certification will not be required for glazing materials bearing
manufacturer's permanent labels designating type and thickness of glass, providing labels
represent a quality control program involving a recognized certification agency or
independent testing laboratory acceptable to the authorities having jurisdiction.
1.05 WARRANTY
A. General: Warranties specified in the Article shall not deprive the Owner of other rights the
Owner may have under other provisions of the Contract Documents and will be in addition to,
and run concurrent with other warranties made by the Contractor under requirements of the
Contract Documents.
B. Manufacturer’s Warranty on Insulating Glass: Submit written warranty signed by
manufacturer of insulating glass agreeing to furnish replacements for insulating glass units
that deteriorate as defined in “Definitions” article, f.o.b. point of manufacture, freight allowed
Project site, within specified warranty period indicated below. Warranty covers only
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
GLASS AND GLAZING 08800-1