Complete Compiled Specification.pdf - Peck Ormsby Construction

2.03 MATERIALS
A. Special Tools:
1. Provide six of each type of special tool for adjusting and regulating hardware. These
are to be turned over to the Owner upon completion.
B. Templates:
1. Furnish hardware templates to each fabricator of doors, frames, and other work, to be
factory prepared for the installation of hardware. Upon request, check the shop
drawings of such other work to confirm that adequate provisions are made for the
project installation of hardware.
C. Silencers:
1. Provide silencers in all metal door frames unless specified elsewhere to be provided
as part of the door and frame unit, or unless continuous bumper-type weatherstripping
is shown or specified. Provide 3 silencers units in a single door frame and provide 4
silencer units in double door frames. Omit silencers from fire-rated door openings.
PART 3 - EXECUTION
3.01 INSTALLATION
A. Mount hardware units at heights recommended in "Recommended Locations for Builder's
Hardware" by DHI, except as otherwise specifically indicated or required to comply with
governing regulations and except as may be otherwise directed by the Architect.
B. Install each hardware item in compliance with the manufacturer's instructions and
recommendations. Wherever cutting and fitting is required to install hardware onto or into
surfaces which are later to be painted or finished in another way, install each item completely
and then remove and store in a secure place during the finish application. After completion of
the finish application, reinstall each item. Do not install surface-mounted items until finishes
have been completed on the substrate.
C. Set units level, plumb, and true to line and location. Adjust and reinforce the attachment
substrate as necessary for proper installation and operation.
D. Drill and countersink units that are not factory prepared for anchorage fasteners. Space
fasteners and anchors in accordance with industry standards.
E. Knox-Box: Mount in masonry wall at 6 feet above the foundation wall. Install recessed
mounting kit plumb and flush with face of wall. Install with four 3/8” grade 5 or grade 8
fasteners to securely anchor box to wall.
1. Locate Knox-Box at front door as shown on the plans or as directed by Architect.
Confirm location with the local fire department prior to installing.
3.02 ADJUST AND CLEAN
A. Adjust and check each operating item of hardware and each door to ensure proper operation
of function of every unit. Lubricate moving parts with type of lubrication recommended by
manufacturer (graphite type if no other is recommended). Replace units that cannot be
adjusted and lubricated to operate freely and smoothly as intended for the application made.
B. Final adjustment: Wherever hardware installation is made more than 1 month prior to the date
of substantial completion, return to the project and adjust all hardware items.
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
FINISH HARDWARE 08700-3