Complete Compiled Specification.pdf - Peck Ormsby Construction

flanges of obstructions. Extend carpet under movable furniture and equipment, unless
otherwise indicated.
C. Install carpet edge guard at locations where edge of carpet is exposed to traffic or where floor
covering materials change, except where another device, such as an expansion joint or
threshold is indicated, with integral carpet binder bar or edge guard. Anchor edge guard to
substrate.
3.05 CLEANING AND PROTECTION
A. Refer to Section 01700.
B. Provide the Owner with a manual of instructions for proper care and cleaning of carpet.
C. Remove spots, smears, stains, etc., immediately with a material recommended by carpet
installation.
D. After installation, sweep and vacuum carpet surfaces clean of all foreign material. Neatly
apply minimum 4 mil thick polyethylene film, firmly fastened to carpet surfaces that are subject
to construction traffic.
E. Remnants: At direction of Architect, leave remnants, of sizes indicated, in possession of
Owner.
END OF SECTION
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
CARPET 09680 - 4