Complete Compiled Specification.pdf - Peck Ormsby Construction

or equivalent. Securely fasten and make absolutely watertight. Provide for adequate
expansion and contraction.
B. Extend flashing 4" beyond jambs of openings. Provide expansion control at all junctions and
straight runs at intervals not exceeding 30 ft.
C. Attach flashing to smooth, sound, dry and clean surfaces, free of defects which might effect
application. Clean surfaces before soldering. Perform soldering slowly with well heated tool to
thoroughly heat the sheet and completely sweat the solder through full width of seam. All lock
seam work shall be flat and true to line and sweated full of solder. Thoroughly wash all acid
flux work after soldering.
D. Wherever possible, secure metal to cleats without nailing. Space nails not more than 8" on
center where exposed to weather use lead washers.
E. Coping: Provide folded standing seam joints. Lap seems are not allowed.
F. Cap flashing joints shall be !" wide. Cover joint with 6" wide joint cover, same shape as cap
flashing, and anchor one side.
G. Install all reglets and expansion joint covers not built into masonry in accordance with
manufacturer's instructions.
3.03 CLEANUP
A. Refer to Section 01700.
END OF SECTION
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
FLASHING AND SHEET METAL 07600-3