Complete Compiled Specification.pdf - Peck Ormsby Construction

C. Accessories:
1. Reinforced wire: Minimum tensile strength of 75,000 psi.
2. Tie wire: 9 gage annealed steel, galvanized.
D. Gates: Swing type as shown on the drawings. Gate fabric and frame same as fence. Hinges
to be pressed steel or malleable iron to suite gate size, non lift-off type. Provide forked type or
plunger type latch with integral padlock eye.
E. Temporary fencing to be galvanized steel pipe post and mesh, with temporary support.
PART 3 - EXECUTION
3.01 EXAMINATION
A. Examine all subsurfaces to receive work and report, in writing, to the Architect any conditions
detrimental to the work. Failure to observe this injunction constitutes a waiver to any
subsequent claims to the contrary. Commencement of work will be construed as acceptance
of all subsurfaces.
3.02 INSTALLATION
A. Fence shall be installed on previously prepared surfaces to line and grade indicated. Comply
with fence manufacturer's instructions and as specified below.
B. Post holes shall be of dimensions indicated, and cleared of loose materials. Set posts plumb
and in alignment. Posts shall be set in concrete bases of dimensions indicated. Thoroughly
compact concrete so as to be free of voids and pockets. Allow concrete to cure at least 72
hours before proceeding with installation of fabric.
C. Provide post caps of the type recommended by the fence manufacturer.
D. Fabric shall be pulled taut and secured to top and bottom rail, to both sides of each post and
at intervals not greater than 24" on centers. Fasten to end posts with stretcher bars.
E. Gates shall be installed to swing freely. Furnish and install all required materials related to
ensure smooth action and stability.
3.03 CLEANUP
A. Refer to Division 1 Section “Contract Closeout.”
END OF SECTION
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
FENCES AND GATES 02830 - 2