Complete Compiled Specification.pdf - Peck Ormsby Construction

1.2 SUBMITTALS
A. Product Data - Manufacturer's original catalog data and descriptive information on each
piece of equipment to be used.
B. Shop Drawings
1. Control diagram for each major and/or minor mechanical and electrical system to
be monitored and controlled. Diagrams will show locations of control and
operational components and devices. ATC diagrams will be generated using
AutoCAD or similar software package drawn on 11 "Xl 7" or larger sheets.
2. Ladder and wiring diagram for each controller.
3. Ladder and wiring diagram for overall control system.
4. Graphics penetration path in block diagram form.
5. Software control schematics which accomplishes each "Sequence of Operation".
6. Full and complete As-Built Drawings must be submitted and approved before
final payment can be made.
C. Closeout
1. Operations And Maintenance Manual Data -
a. Requirements are as follows -
1) Provide operating and maintenance instructions for each item of
equipment submitted under Product Data.
2) Include copy of approved shop drawings.
3) Provide all documentation hard copy and in digital format on CD
format
1.3 QUALITY ASSURANCE
A. Pre-Installation Meeting - Schedule meeting with Division 16 and Division 15 installation
contractors before installation of system begins.
1.3 SCHEDULING
A. Coordination
Coordinate planning and installation of equipment with parties specified to be
involved in BMCS including but not limited to:
a. BMCS Contractor
b. Electrical Subcontractor
c. Mechanical Subcontractor
d. District
e. Architect and Consultants
f. Balancing Subcontractor
PART 2 - PRODUCTS
2.1 COMPONENTS
A. The following is a list of approved component manufacturer's:
Work Station -
a. Processor -Intel Pentium IV
b. 512 Meg RAM
c. R/W CDROM
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION
AUTOMATIC TEMPERATURE CONTROLS 15900-2