Complete Compiled Specification.pdf - Peck Ormsby Construction

10. Install metal corner reinforcement at all external corners. Conceal flanges of metal
reinforcing with at least 2 coats of compound. When completed, compound shall
extend approximately 8" to 10" on each side of metal nosing.
11. After each application of joint or finishing compound has dried, lightly sand all joints
and leave all board and treated areas uniformly smooth ready for painting.
12. Where walls run to underside of deck, all voids in deck must be filled and sealed with
dry wall, insulation or if rated, then one-hour material approved by the Architect.
13. Do all cutting and patching where drywall construction must be penetrated by other
trades.
F. Sound Attenuation Batts:
1. Comply with manufacturer's instructions for particular conditions of installation in each
case.
2. Batts may be friction-fit in place until the interior finish is applied. Install batts to fill
entire stud cavity. If stud cavity is less than 96" in height, cut lengths to friction-fit
against floor and ceiling tracks. Carefully cut batts to fit around outlets, junction boxes
and other irregularities.
3. Where walls are not finished on both sides, or insulation does not fill the cavity depth,
provide supplementary support to hold product in place.
4. Where insulation must extend higher than 8 feet, provide temporary support to hold
product in place until the finish material is applied.
3.03 CLEANUP
A. Refer to Section 01700.
END OF SECTION
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
GYPSUM BOARD ASSEMBLIES 09250-5