Complete Compiled Specification.pdf - Peck Ormsby Construction

SECTION 07410 - PRE-FORMED METAL PANELS
PART 1 - GENERAL
1.01 DESCRIPTION OF WORK
A. Provide all un-insulated metal wall and soffit panels as shown and noted on drawings.
1.02 RELATED WORK SPECIFIED ELSEWHERE
A. Primary and secondary structural steel.
B. Division 7 Section “Manufactured Roof Panels” for metal roofing
1.03 QUALITY ASSURANCE
A. Manufacturer and erector shall demonstrate a minimum of five years of related industry
experience.
B. Profile and gauges of panels shall beet a wind load of 70 MPH for panels without exceeding a
deflection of L/180.
1.04 SUBMITTALS
A. No less than ten days prior to bid date, submit all independent laboratory test reports, design
and performance data as specified.
B. Prior to fabrication, submit erection/shop drawings for products specified, showing all erection
procedures and accessories required.
C. Refer to Section 01300.
PART 2 - PRODUCTS
2.01 MATERIALS
A. Manufacturer: MBCI (or approved equal).
B. 22 gauge 2 1/2" corrugated metal panel.
1. Finish to conform to Signature 300. Color selected by architect from manufacturer
standard colors.
C. The flashing and trim shall be of the same material, gauge, finish and color(s) as the panels,
unless otherwise indicated.
D. Accessories:
1. Provide all required trim and closures for a complete and weathertight finish.
2. Provide all required fastening devices as required.
E. Accessories:
1. Fasteners: #14 diameter pre-painted self drillers.
2. Tape Sealant: A non-hardening shall be installed at all roof side laps and wall side
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
PRE-FORMED METAL PANELS 07410 - 1