Complete Compiled Specification.pdf - Peck Ormsby Construction

E. Flush floor receptacles to be duplex and to have brass or aluminum, hinged flap lids. Provide
carpet flanges in carpeted floors. (See 16050, 2.4, E.)
F. Wet location and/or weatherproof receptacles shall be in a weatherproof enclosure, the
integrity of which is not affected when the receptacle is in use (attachment plug cap inserted),
UL labeled and listed “Suitable For Wet Locations While In Use”. Provide enclosure with
stainless steel screws, gasket between enclosure and mounting surface and between cover
and base, clear impact resistant UV stabilized polycarbonate as manufactured by TayMac
Corporation or accepted equivalent.
PART 3 - EXECUTION
3.1 GENERAL:
A. Provide a separate GFI type receptacle for each receptacle noted on plans as GFI. Standard
receptacles fed from an up-stream GFI type receptacle are not acceptable.
B. Install outlets and switches in a neat manner.
C. Extend mudrings to flush out with surrounding wood panels and walls.
D. Faceplates, devices, and boxes shall be square with floor, and door lines.
E. Devices to be installed flush with faceplate.
3.2 LABELING:
A. Where switches control remote lighting or power outlets, or where switches in the same outlet
(two or more) serve different purposes, such as light, power, intercom, etc. or different areas,
such as corridor and outside, furnish engraved plates with 1/8 inch black letters indicating
function of each switch or outlet.
END OF SECTION
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION March 2, 2009
SWITCHES & RECEPTACLES 16140-2