Complete Compiled Specification.pdf - Peck Ormsby Construction

PART 3 - EXECUTION
3.01 INSPECTION
laps of office area.
A. The installer shall examine the building to verify that the structure is ready for installation.
B. All structural supports shall be in place and all sag rods, diagonal bracing and connections
shall be tightened before work proceeds.
C. Field check dimensions and check support alignment with a taut string or wire; support
misalignment will cause panel "oil-canning".
D. Do not proceed until unsatisfactory conditions are corrected.
3.02 INSTALLATION AND ERECTION
A. Install metal panels, fasteners, trim, and related items in conformance with approved
drawings.
B. Protect installed panels from abuse by other trades. The general contractor shall be
responsible for protecting the panels from wet cement, plaster, painting operations, etc.
3.03 DAMAGED MATERIAL AND CLEANING
A. Replace damaged panels and other components of work which cannot be repaired by finish
touch-up or similar minor repair.
B. To prevent rust staining, remove immediately from finished surfaces any filings caused by
drilling or cutting.
C. Wipe down each area after erection is complete for final acceptance.
D. Refer to Section 01700.
END OF SECTION
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDITION MARCH 2, 2009
PRE-FORMED METAL PANELS 07410 - 2