Complete Compiled Specification.pdf - Peck Ormsby Construction

alance, and operation. If valves are installed in inaccessible locations it shall be this contractor's responsibility
to furnish and install access doors of a type approved by the owner's representative.
Locate piping, valves, etc., to allow easy access to and maintenance of equipment. Do not block walkways, filter
access, maintenance access, or tube-pull space in equipment rooms.
LOCATIONS & ARRANGEMENTS:
All pressure gages shall be so installed as to be easily readable from an eye level 5' -6" above the floor.
Test plugs on flow measuring stations shall be unobstructed, and shall be arranged in the piping per
manufacturer's recommendations.
All equipment and accessories shall be installed to facilitate proper service and maintenance in compliance with
the manufacturer's recommendations.
WIRING BY THE ELECTRICAL CONTRACTOR:
It is the intent of these specifications that all line voltage electrical power and control wiring, and power
connections to equipment, be furnished and installed by the electrical contractor unless otherwise specified or
shown on the mechanical drawings.
The mechanical contractor shall coordinate actual job-site power requirements of mechanical equipment being
furnished by him with the electrical contractor prior to installation of power wiring and electrical equipment.
The electrical contractor shall provide necessary wiring to electric heat tape as required, and shall coordinate
with the mechanical contractor the location and capacity of required circuits.
When mechanical system components are furnished with remote mounted control panels, alarm bells,
alternators, etc. the electrical contractor shall run all required line voltage (power and control) wiring as directed
by the mechanical contractor. It shall be the mechanical contractor's responsibility to coordinate the work and
provide the necessary wiring diagrams.
When exhaust fans are provided which are not controlled by the ATC contractor, they shall be wired by the
electrical contractor to local line voltage wall switches. The wall switch locations shall be coordinated with the
owner's representative.
STORAGE AND INSTALLATION OF MOTORS:
Handle motors carefully to prevent damage, denting and scoring. Do not install damaged motors or
components; replace with new.
Store motors and components in a clean, dry place. Protect from weather, dirt, water, construction debris, and
physical damage.
Install motors where indicated on the drawings and in accordance with manufacturer's drawings and in
accordance with manufacturer's published installation instructions.
______________________________________________________________________________________
SEGO LILY ELEMENTARY SCHOOL CLASSROOM ADDTION March 2, 2009
BASIC MATERIALS & METHODS 15050-26