RL78/D1A User's Manual: Hardware - Renesas

Under development
Preliminary document
Specifications in this document are tentative and subject to change.
RL78/D1A CHAPTER 32 ELECTRICAL SPECIFICATIONS (J GRADE PRODUCT) (TARGET)
TA = -40 to +85 C, 4.0 V VDD = SMVDD0 = SMVDD1 5.5 V, VSS = SMVSS0 = SMVSS1 = 0 V
Parameter Symbols Conditions Min. Typ. Max. Unit
Input voltage, high VIH1 0.8VDD VDD V
Input voltage, low VIL1 0 0.5VDD V
Input hysteresis width
Note 1
VIHYS1 0.1 0.19 0.29 V
Output voltage, high VOH1
Output voltage, low VOL1
Output voltage
Note 2
deviation
Input leakage current,
high
Input leakage current,
low
On chip pull-up
Note 3
resistance
On chip pull-down
Note 4
resistance
TA = -40 C IOH = -52 mA
TA = +25 C IOH = -39 mA
TA = +85 C IOH = -32 mA
TA = -40 C IOL = 52 mA
TA = +25 C IOL = 39 mA
TA = +85 C IOL = 32 mA
VDD-0.5 VDD V
0 0.5 V
VDEV 0 50 mV
ILIH1 VI = VDD 1 A
ILIL1 VI = VSS -1 A
RU VI = VSS 10 20 100 k
RD VI = VDD 100 k
Notes 1. This spec is guaranteed by design. It is not tested when shipment.
2. Output voltage deviation defines the difference of the outputs levels of the same stepper motor.
VDEV = max (|VOHx-VOHy|, |VOLx-VOLy|) @IOHx = IOHy, IOLx = IOLy.
X and y denote any combination of two pins of the following pin groups: (P80-P83, P84-P87, P90-P93,
P94-P97)
3. Pull-up resistance is connected by software when pin is set to input mode.
4. LCD segment shared pins only. Pull-down resistance is connected during reset.
R01UH0317EJ0004 Rev. 0.04 1223
Feb. 22, 2013