RL78/D1A User's Manual: Hardware - Renesas

Under development
Preliminary document
Specifications in this document are tentative and subject to change.
RL78/D1A CHAPTER 33 ELECTRICAL SPECIFICATIONS (L GRADE PRODUCT) (TARGET)
33.4.2 Pin group 2 (ANI pins)
TA = -40 to +105 C, 4.0 V VDD 5.5 V, VSS = 0 V
Parameter Symbols Conditions Min. Typ. Max. Unit
Output current, high IOH1 Per pin -0.1 mA
IOHTOTAL Total -0.8 mA
Output current, low IOL1 Per pin 0.4 mA
IOLTOTAL Total 3.2 mA
Input voltage, high VIH1 0.8VDD VDD V
Input voltage, low VIL1 0 0.5VDD V
Input hysteresis width Note VIHYS1 0.1 0.19 0.29 V
Output voltage, high VOH1 IOH = -0.1 mA VDD-0.5 VDD V
Output voltage, low VOL1 IOL = 0.4 mA 0 0.4 V
Input leakage current,
high
ILIH1 VI = VDD 1 A
Input leakage current,
low
ILIL1 VI = VSS -1 A
Note This spec is guaranteed by design. It is not tested when shipment.
TA = -40 to +105 C, 2.7 V VDD 4.0 V, VSS = 0 V
Parameter Symbols Conditions Min. Typ. Max. Unit
Output current, high IOH1 Per pin -0.1 mA
IOHTOTAL Total -0.8 mA
Output current, low IOL1 Per pin 0.4 mA
IOLTOTAL Total 3.2 mA
Input voltage, high VIH1 0.8VDD VDD V
Input voltage, low VIL1 0 0.4VDD V
Input hysteresis width Note VIHYS1 0.05 0.21 V
Output voltage, high VOH1 IOH = -0.1 mA VDD-0.5 VDD V
Output voltage, low VOL1 IOL = 0.4 mA 0 0.4 V
Input leakage current,
high
ILIH1 VI = VDD 1 A
Input leakage current,
low
ILIL1 VI = VSS -1 A
Note This spec is guaranteed by design. It is not tested when shipment.
R01UH0317EJ0004 Rev. 0.04 1252
Feb. 22, 2013